The gas analyser GA-21Bio plus is designed for use in waste plants where it is necessary to measure the gases produced and the emissions from a connected power or heat generation station. This is now possible with a single instrument thanks to the use of the most modern technology. Like all our instruments, the GA-21Bio plus is manufactured to give a long working life.
Using the optional dryer it is possible to carry out longer term measurements. Three extra analogue inputs allow the simultaneous measurement of a voltage or current signal and a temperature. This makes it ideally suited for measurements on district heating plants. Manufactured with EN50379 in mind. - Measurement of gas concentrations
- Gas concentrations measured with NDIR sensors: CO2, CH4
- Gas concentrations measured with electrochemical sensors: O2, CO
- Toxic gas concentrations measured with electrochemical sensors: CO, NO, NO2, SO2, H2S. Please ask for quote for other gases.
- Measurement of other parameters
- Measurement of gas and ambient temperatures
- Pressure, draft and differential pressure measurements with 1 Pa resolution
- Soot test according to Bacharach with a pump flow of 1.62 l/min
- Three analogue inputs (1 current/voltage, 1 thermocouple, 1 thermistor)
- Calculation
- Calculation of absolute and relative mass concentrations & relative emissions
- Calculation of all relevant combustion parameters
- Processing and presentation of measured data
- All results shown on display
- Averaging of all measured values. Averaging time: 10 sec - 60min
- Graphical presentation of all measured values as diagram (option)
- Memory capacity for 1024 sets of data, organised into 10 data banks
- Up to 9 separate items in a data set
- User definition of the 9 items
- Memory capacity for 30 reports
- Data logger function for the analogue inputs
- All measured values, stored values or displays can be printed on the internal printer.
- Powerful PC program for analyser settings and data communication
- Software-Eigenschaften
- International compatibility (language, date format etc.)
- Password protection for settings
- Automatic zeroing when the analyser is switched on
- Calibration of O2/CO2 during use
- All parameters programmable
- List of 22 common fuels
- 10 further freely programmable fuels
- Permanent automatic check of the instrument with acoustic warning and full information in the "control list"
- Compensation of cross sensitivity and temperature drift of gas sensors
- Hardware capabilities
- Electronic regulation of the pump flow rate
- Integrated clock/calendar
- Internal 57 mm dot-matrix printer
- Power from rechargeable battery or mains
- Big (70 x 60 mm) LCD display with backlighting (Graphics or 11 x 21 characters)
- Gas probe with thermocouple and condensate trap
- Power for heated probe holder during mains operation
- RS-232C interface and multifunctional PC program
|
Print
